Opened exterior wall exposing repaired pipe with new copper lines and brass valves

Above ground. Below ground. Du-All.

Water Leak Detection Lantana

Leak detection for your Lantana home or business.

Water leak detection in Lantana matters because small failures add up fast. The Town's Utilities Department estimates a failed toilet flapper can waste about 5,000 gallons a day and a customer-side pipe break far more.

Call 561-623-3111 Request Service

$37 off your next service callClaim this offer →

Request service

Tell us what’s happening.

Share your property address and the problem you’re seeing. A Du-All team member will call you to arrange service.

This request does not confirm an appointment. To speak with the team, call 561-623-3111.

A+ rated by the Better Business BureauView our BBB profile →

4.6/5 on Google348 reviews · Lake Worth BeachRead Google reviews (opens in a new tab)

Lantana leak checks using the Town's own numbers

Quick answer

How much water can a hidden leak waste in Lantana?

Water leak detection in Lantana, 33462, for homes along the Lantana Road corridor and on the Lantana portion of Hypoluxo Island, served by the Town of Lantana Utilities Department.

The Town of Lantana's leak numbers, and what to do with them

The Lantana Utilities Department publishes rough estimates of how much water common problems can waste. They are useful for judging how urgent a high bill is:

Toilet flapper that will not seal: possible excess of about 5,000 gallons per day. Symptom: a tank that keeps filling or refills on its own.
Outdoor spigot left open: about 10,000 gallons per day.
Irrigation left on: roughly 500 to 2,500 gallons per day, depending on meter size and number of heads. Broken heads raise flow further.
Pipe break on the customer's side of the meter: from 100 to as much as 200,000 gallons per day, depending on meter and pipe size.

For comparison, the Town says single-family homes typically use 2,000 to 20,000 gallons a month without lawn irrigation. If your bill is far outside your own normal range, look for one of these first.

Water leak detection illustration for Lantana, FL: a tile floor with a single cracked, damp grout line in a living room — Representative illustration of a tile floor with a single cracked, damp grout line in a living room. Not a photo of a Du-All job or of any specific Lantana property.

What does the Town's code say about leaks and meters?

Lantana's utility rules are short and direct. The Town reads meters monthly, and the customer pays for the consumption the meter shows. If a customer believes a leak has resulted in an unfair charge, the code allows them to contact the Town and request an informal hearing. That is a request for review, not a promised credit, so bring clear records: meter readings, the repair invoice and photos.

The same section makes it unlawful for anyone not authorized by the Town to tamper with, alter or damage a meter or curb stop, and damage is repaired at the customer's expense. In practice that means you can read the meter, but you should not adjust it, remove it or operate the curb stop. Use the shutoff on your side instead. The code also notes that repairs on customer property or Town property must be permitted by the Town building department.

Why does irrigation deserve a close look in Lantana?

The Town's tips point out two irrigation problems that are easy to miss. First, broken sprinkler heads reduce the system's resistance to flow, so the same watering schedule uses more water than before. Second, because the water system is always pressurized, an irrigation valve that is not fully closed can let water flow through heads in a way that is not obvious. A lawn that seems normal can still be costing you.

To check, turn the irrigation controller off and do a quiet meter test. As the Town's note implies, the controller alone does not close a stuck valve, so continued movement can still be irrigation; closing the irrigation system's own shutoff, where one exists, gives a cleaner answer. If the meter stops, the sprinkler system is a strong suspect. Then run each zone and walk it, looking for geysers, heads that do not rise, and soggy areas. We repair the supply piping and valves; head replacement and programming are often done by a landscaper. Our post on leaky pipes and your water bill covers indoor leaks too.

How do I run a fair meter test?

Pick a time when nobody needs water. Turn off taps, the dishwasher, washing machine, ice maker and irrigation, and if you have guests, wait until they are out. The Town notes that guests use water too, so a busy month can look like a leak. Note the meter reading. EPA WaterSense suggests waiting about two hours with no use and checking again. If the number changed, something used water.

Next, test the toilets: a few drops of food coloring in each tank, ten minutes without flushing, then look for color in the bowl. If you have a house shutoff that turns freely, close it and watch the meter. A meter that stops points inside the house; one that keeps turning points to the service line. Do not force valves, and do not operate the Town's curb stop.

Du-All offer

$37 off

Your next service call

Not valid with other offers. Not valid on prior service. Limit one coupon per service call.

Call 561-623-3111 Claim This Offer

Is the island side of town any different?

Part of Hypoluxo Island lies within Lantana, and homes there sit near the ocean and the Intracoastal. Wind-driven rain can enter around windows and doors, and air conditioning condensate overflows are common causes of wet walls that are not plumbing at all. Condominium buildings add shared risers and association-controlled shutoffs, and a stain may come from a neighbor's unit above.

Confirm which utility bills your address before calling about a meter, since jurisdictions on the island differ. If your building shares a master meter, a resident's test cannot isolate one unit. In that case, check your own fixtures and arrange a plumbing inspection through management. Our leak detection and repair page explains how we approach both houses and condos.

Which signs inside the house point to a hidden supply line?

When the toilets pass the dye test, the irrigation is off and the meter still moves, the leak is probably somewhere you cannot see. Listen near walls and floors when the house is silent; a steady hiss or trickle is a strong clue. Feel tile floors for a warm patch, which can mean a hot water line leaking under the slab. Look for paint that bubbles near the base of a wall, baseboards that swell, or a cabinet floor that stays damp after you dry it.

Each sign has other possible causes, so we combine them with the meter result, the location of fixtures and whether hot or cold water seems to be involved. That tells us where to start and helps keep any opening of walls or floors small and purposeful. Write down what you noticed and when, since the timeline often helps more than any single clue.

What should I do if a pipe bursts?

Close your house shutoff or the fixture valve if it is safe to reach and turns without force. Keep away from water near outlets, cords and the electrical panel, and stay out from under sagging ceilings. Move belongings and photograph the damage before cleanup. Then call a plumber. If water is pouring from the meter or the street, call the Town's Utilities Department rather than touching its equipment.

Once the pipe is repaired, large leaks may need professional drying, and your insurer may want to see the damage first. Lasting moisture can lead to mold, as our article on mold growth in homes explains. We describe what failed and how it was repaired, which supports an informal hearing request if you think the bill was unfair. For non-urgent questions, use our contact page.

What happens after the leak is located?

We explain what failed and lay out the repair options before starting. A flapper, fill valve or supply hose is quick to replace. A leak inside a wall or under a slab may mean opening a section of wall or floor, or rerouting a line to avoid the slab. Some repairs need a permit from the Town. We will not claim a repair can always be done without opening anything, and we do not quote prices before we see the problem.

Nearby leak detection pages: water leak detection in Hypoluxo, water leak detection in Lake Worth, water leak detection in Manalapan.

Before you call

Lantana leak detection questions, answered

Will the Town of Lantana forgive water lost to a leak?

The code lets a customer who thinks a leak caused an unfair charge contact the Town and request an informal hearing. It does not promise a credit. Bring meter readings, the repair invoice and photos.

Can I turn off the water at the curb stop?

The Town's code says it is unlawful for unauthorized people to tamper with a meter or curb stop. Use the shutoff on your side of the meter, or call the Utilities Department.

How much water does a typical Lantana home use?

The Town estimates 2,000 to 20,000 gallons a month for single-family homes without lawn irrigation. Compare your bill to your own history first.

Why did my bill rise when the sprinkler schedule did not change?

The Town notes broken heads let more water through and a partly closed valve can let water flow unseen. Close the irrigation supply valve if you have one and repeat a meter test; the controller alone will not stop a stuck valve.

Do leak repairs in Lantana need a permit?

The Town's code says repairs on customer or Town property must be permitted by the building department. Many fixture repairs are minor, but larger piping work may need one.