Opened exterior wall exposing repaired pipe with new copper lines and brass valves

Above ground. Below ground. Du-All.

Water Leak Detection Stuart

Leak detection for your Stuart home or business.

Du-All Plumbing provides water leak detection in Stuart. We trace unexplained water use on the customer side of the meter, separate supply leaks from drain, roof and irrigation water, and explain the repair options before work begins.

Call 772-238-6456 Request Service

$37 off your next service callClaim this offer →

Request service

Tell us what’s happening.

Share your property address and the problem you’re seeing. A Du-All team member will call you to arrange service.

This request does not confirm an appointment. To speak with the team, call 772-238-6456.

A+ rated by the Better Business BureauView our BBB profile →

4.6/5 on Google348 reviews · Lake Worth BeachRead Google reviews (opens in a new tab)

Finding hidden leaks behind Stuart meters, walls and slabs

Quick answer

Who handles water leak detection in Stuart, FL?

A Stuart leak often starts as a number on a bill or a stain that will not dry. Du-All Plumbing investigates water leaks in homes and businesses across Stuart, from the blocks around downtown to addresses served by Martin County water, and tells you plainly what we found and what the choices are.

Which utility reads your Stuart meter, and why does it matter?

Stuart is unusual because a Stuart mailing address does not tell you who sells you water. The City of Stuart Utility Division says its service area covers about 3.4 square miles, including most properties inside city limits and a small piece of unincorporated Martin County. Many homes with a Stuart address sit outside that area and buy water from Martin County Utilities instead. Before we start chasing a leak, it helps to look at your bill and note which utility issued it, because that is who you will talk to about the meter, the service line on the street side, and any billing review.

If the City is your provider, it publishes a short leak test sheet. It tells customers to make sure no water is used inside or outside, record the meter reading, watch the red dials, then avoid running water for at least two hours and read again. A changed reading suggests a possible leak. The same sheet states that repairs on the owner's side of the meter are the owner's responsibility and that a customer who finds a leak may qualify for a leak adjustment, with details from Customer Service. The City also lists a Leak Adjustment Form among its utility documents. We do not decide who qualifies, and no credit is promised, but a clear written description of what we found and fixed is the kind of record a utility review usually asks for.

Water leak detection illustration for Stuart, FL: a ground-floor condo patio with water seeping under the slider — Representative illustration of a ground-floor condo patio with water seeping under the slider. Not a photo of a Du-All job or of any specific Stuart property.

What can a moving meter tell you, and what can it not?

A meter that keeps turning while everything is off tells you water is passing the meter. It does not tell you where it is going. In a typical Stuart house the list of suspects is long: a toilet flapper that lets the tank refill every few minutes, an ice maker line behind the refrigerator, a washing machine hose, a hose bib left cracked open, an irrigation zone with a stuck valve, and only then a pipe buried in a slab or wall. EPA WaterSense notes that the average household's leaks can add up to more than 9,300 gallons a year, and most of that comes from ordinary fixtures, not dramatic pipe breaks.

So the first part of our visit is elimination. We confirm that known uses are paused, check toilets and fixtures, isolate irrigation where a separate valve allows it, and watch how the meter behaves as each branch is ruled out. If the irrigation system runs from the same meter, a sprinkler leak can look exactly like a house leak on the bill. Our article on how leaky pipes add to a water bill covers the basic math if you want to estimate what a slow leak costs.

A safe meter check before you call

You can do a useful first check yourself without touching utility equipment. Pick a two hour window when nobody will use water, confirm the dishwasher, washer and irrigation timer are not scheduled to run, and write down the reading you can see. Read it again at the end. If you cannot read the meter without prying a lid, lifting a heavy cover or reaching into standing water, stop there and let us or the utility handle it.

Do not force a stiff main valve. A valve that will not turn by hand can break, and that turns a slow leak into a fast one.
Never open, adjust or bypass the utility meter or its lock. That equipment belongs to the provider.
Write down both readings and the times. Those numbers help us choose where to start.

Is it a supply leak, a drain leak, or water from outside?

Not every wet ceiling or damp baseboard is a pressurized pipe. In Stuart we see water that turns out to be an air handler condensate line backing up, a shower pan seeping into the next room, a roof flashing failure that only shows after rain, or a drain joint that leaks only when a tub empties. These do not move the water meter at all, which is one reason the meter test matters: a quiet meter with a fresh stain points away from the supply piping.

When the meter is quiet, we look at timing. Does the stain grow after showers, after storms, or after the AC has run all afternoon? Drain and fixture problems often lead to our toilet repair or drain work instead of leak locating, and a roof leak is a roofing contractor's job. We will tell you when the water is not a plumbing problem rather than open a wall to find out.

Du-All offer

$37 off

Your next service call

Not valid with other offers. Not valid on prior service. Limit one coupon per service call.

Call 772-238-6456 Claim This Offer

How does Du-All narrow down a hidden leak?

Once the leak is confirmed on the supply side, we work from the outside in. We look at where the service line enters the building, check accessible valves and fittings, compare hot and cold sides, and check for warm spots, damp grout or flooring that has lifted. Separating the hot side from the cold side matters, because a hot water leak also wastes the energy used to heat it, and it often leads back toward the water heater connections or a hot line under the slab.

We are careful about promises. The goal is to narrow the location enough that any opening is small and placed where it will do the most good, but we cannot guarantee that no drywall, tile or concrete will need to be opened. Before any cutting we explain what we expect to find, what the repair might involve, and whether rerouting a line might make more sense than breaking into a finished floor.

When should you shut the water off right now?

If water is spraying, pooling quickly, or coming through a ceiling, close the customer-side main shutoff if you can reach it and turn it by hand safely. Keep away from water near outlets, panels or appliances, and stay out of any room where the ceiling is sagging. Then call us at 772-238-6456. Do not dig near the meter or service line to look for a break; buried utilities need to be located first, and the street side belongs to your water provider.

After the water is stopped, the job splits into three parts that people often blur together: finding the leak, repairing the pipe, and drying or restoring the building. We handle the first two. Wet drywall, cabinets and flooring may need a drying or restoration company, and our page on mold growth in homes explains why trapped moisture should not be left alone.

Stuart properties we commonly visit, and nearby leak pages

We work across Stuart ZIP codes including 34994, 34996 and 34997, from downtown Stuart to streets off SE Ocean Boulevard and the Stypmann Boulevard area. Condo and townhome owners should check with the association before work begins, since shared walls and common risers can mean the leak, or the repair responsibility, sits outside your unit. A single shared meter also cannot show which unit is using water, so association records and access matter.

Neighbors in Martin and St. Lucie counties can read our local pages for water leak detection in Palm City, Port Salerno leak detection and Port St. Lucie leak detection. To book a visit, use our contact page or start from the main leak detection and repair service page.

Before you call

Stuart leak detection questions, answered

Does the City of Stuart supply water to every Stuart address?

No. The City says its utility covers about 3.4 square miles, mostly inside city limits. Many Stuart mailing addresses are served by Martin County Utilities. Check the name on your bill.

How long should my Stuart meter test run?

The City of Stuart leak test sheet suggests no water use for at least two hours, with a reading at the start and end. A change suggests a possible leak, not its location.

Can I get a leak adjustment on a Stuart water bill?

The City says customers who find a leak may qualify and lists a Leak Adjustment Form. Eligibility is the utility's decision, so contact its Customer Service before assuming a credit.

My sprinklers share the meter. Could they be the leak?

Yes. An irrigation leak moves the same meter as a house leak. We isolate irrigation where the valves allow it before looking for a hidden pipe.

I am in a Stuart condo. Who is responsible for the leak?

It depends on where the leak is and your association documents. Shared walls and risers may belong to the association, so involve the manager early.

Will you have to open my wall or floor?

Sometimes. We narrow the location first to keep any opening small, and we explain the options before cutting. No one can honestly promise zero openings.